
Most adjustable guide rods on the market use a cap screw to retain the spring. The problem? Loose screws are too common and thread locker forces you to commit to one spring weight.
Enter the screwless design of the COMPRESSOR Quick-Tune Guide Rod. The dovetail interface is captured by the spring, creating a simple and secure lock-up. Flutes along the guide rod allow the spring to move with less friction for smoother cycling. The heat treated guide rod has a slick, durable, and corrosion-resistant Nitride finish.
COMPATIBILITY:
MR920/P/L
XR920/P
DR920/P/L
1 - COMPRESSOR GUIDE ROD
1 - COMPRESSOR BUSHING
1 - COMPRESSOR CAP
1 - GEN3 WASHER
3 - UNIQUELY WEIGHTED SPRINGS
1 - COMPRESSOR TOOL
STEP 01 | Compress installed spring and insert tool* into the cross hole to hold the spring down.
STEP 02 | Remove the dovetailed end cap. Then remove the tool from the cross hole, allowing the spring to be removed.
STEP 03 | Install a different spring weight, compress new spring, and insert the tool back into the cross hole again.
STEP 04 | Align dovetail to install cap, remove the tool, and allow spring to capture around the dovetail interface.
*While a tool is not necessary for the Radian guide rod, it can assist in holding the spring down when removing and installing the cap.
Although the Radian® COMPRESSOR™ was designed for OEM hosts, it is compatible with many aftermarket hosts. To confirm compatibility with your specific slide, send an email to support@radianweapons.com and the Customer Service Team can confirm fitment.
8BMX3